好难过,国人真不如白人好!

你说得也许有道理,但连续三个同胞拒绝,而一个白人就很爽快地帮忙,我心里很不是滋味,不单单是为被拒绝,而更多地是为从这件小事上想到在加华人的心态。

如果你感兴趣的话,你不妨去Lowblaws和大统华的停车场做个比较试验。

楼主,理解你的心情。只能想当然的安慰你,你运气不好,问到的三个华人朋友都有急事或者其他的原因,不是简单地冷漠的拒绝你。只有你放下了,释怀了就好了。
另外,这个事,我会建议去大统华或者lowblaw 的服务台,虽然不是他们的份内事儿,但我相信,你说明情况以后,没有任何的obligation 和liability, 做customer service的,这点小事应该是可以帮忙的。
毕竟,赠人玫瑰,手有余香!
 
会布斯特车的人不少,能够按正常步骤做的人不是很多,N年前听说过帮人跳电引起着火的。。。 我想长乐碰到的三个人可能从来都没有跳过电!:jiayou::p
这个布斯特的四个夹子上的过程有个程序吧? 特别是夹子和夹子不能碰了!
 
楼主,理解你的心情。只能想当然的安慰你,你运气不好,问到的三个华人朋友都有急事或者其他的原因,不是简单地冷漠的拒绝你。只有你放下了,释怀了就好了。
另外,这个事,我会建议去大统华或者lowblaw 的服务台,虽然不是他们的份内事儿,但我相信,你说明情况以后,没有任何的obligation 和liability, 做customer service的,这点小事应该是可以帮忙的。
毕竟,赠人玫瑰,手有余香!
向西走到audi车行找路顺也成。:good:
 
会布斯特车的人不少,能够按正常步骤做的人不是很多,N年前听说过帮人跳电引起着火的。。。 我想长乐碰到的三个人可能从来都没有跳过电:p

顺便普及下, 什么步骤啊, 不就是正级跟负级一接吗?
 
好高的楼啊。。。。嗯,补充两句

1. 要是手动车. 能推起来: 挂一档,你坐车里掌握方向盘,有两人在后面推,车就起来了。 以前就这么做过,不知道自动车能不能推起来。
2. 现在的拖拉机,也不是手摇启动了。 哪是以前的手扶拖拉机,用的是单缸四冲程 195 柴油机。

自动车不行
 
好高的楼啊。。。。嗯,补充两句

1. 要是手动车. 能推起来: 挂一档,你坐车里掌握方向盘,有两人在后面推,车就起来了。 以前就这么做过,不知道自动车能不能推起来。
2. 现在的拖拉机,也不是手摇启动了。 哪是以前的手扶拖拉机,用的是单缸四冲程 195 柴油机。
何叔,歪个楼回报一下:
又自做主张弄了个爱淘客BB,你嘛也就是一个OBIHAI202,俺介就给退了去。
 
Directions
  • Pull the running vehicle up close to the one that won’t start. This can either be side-by-side or hood to hood. Just make sure they are close enough for the cables to reach both.
  • Take out the cables and make sure to never touch the ends to each other at any time.
  • First work with the running vehicle. Take one end of the cables and attach them to the battery which is usually up front near the corner of the car when the hood is popped up.
  • There are always two posts on a battery, one is positive and the other is negative. The positive post is usually bigger than the negative, has more wires going to it, is frequently colored red and has a + sign beside the post. *See Pictures Below
  • Working with the same end of the booster cable (one red clamp and one black clamp):
  • Clamp the red end of the cable to the positive post.
  • Next clamp the black end of the cable to the negative post.
  • Now you should have both clamps from one end of the cables attached to the battery of the ‘working’ car.
Very Important: Make sure to NEVER let the clamps of the cables on the loose end touch each other or you will have flurry of sparks.

  • Working with the ‘dead’ car and the other end of the cables, follow the exact same procedure above. First attach the red positive clamp to the positive post, and the black negative clamp attach to a grounded piece of sheet metal of the vehicle (read comments below).
Important: Make sure to attach the red positive clamp first, then the black negative clamp.

  • Now both ends of the cables should be attached, one end to each automobile. Red clamps attached to each positive post, and black clamps attached to the negative post on the running auto and the other negative clamp attached to a grounded metal part of the other vehicle.
  • First turn on the ‘working’ vehicle. Then try starting the ‘dead’ auto. If it doesn’t start right away, you may need to let the running vehicle run for a minute or two to charge it, then try starting the dead auto again.
  • If the dead car still doesn’t start, make sure the clamps are on the posts properly and have not fallen off.
  • Once the “dead” vehicle is running, do not shut it off. Keep it running so it recharges.
  • Remove the cables from one automobile at a time.
Important: First remove the black negative clamp, then the red positive clamp.

  • Hold the detached clamps in one hand away from the other end while removing the second cable end from the second automobile–or sparks galore again.
  • Once the cable has been removed from both autos, it’s safe to wind them up and put them away.
 
何叔,歪个楼回报一下:
又自做主张弄了个爱淘客BB,你嘛也就是一个OBIHAI202,俺介就给退了去。
italkbb 用obi202?
 
何叔,歪个楼回报一下:
又自做主张弄了个爱淘客BB,你嘛也就是一个OBIHAI202,俺介就给退了去。
爱淘客BB现在用OBIHAI202了? 行,还真舍得!

BTW,俺昨天折腾了一晚上,现在那个 roku 的地址是美国的了 :D
 
italkbb 用obi202?
外表涨得一模一样。。。老何没啥出息,也就会家里倒吃。。。咱俩开个italkCCC?这玩意是趋势。
 
后退
顶部