问个主板问题～ 急～ THX
- 主题发起人 173KN-dc
- 开始时间
Google一下就可以知道答案了
The Promise PDC20378 chip used on many motherboards will emit the following message when it is in RAID mode, but after a 7-second scan, it finds that no hard drives are attached to any of its ports. The chip supports 2 SATA ports (often labelled "SATA_RAID1" and "SATA_RAID2", and also one IDE port (often labelled "PRI_RAID").
FastTrak 378 (tm) BIOS Version 1.00.1.34
(c)2002-2005 Promise Technology, Inc. All rights reserved.
Scanning IDE drives.......
No drive attached to FastTrak controller, The BIOS is not installed.
The message is an informational warning only. It may be ignored. Its purpose is to tell you that in case you thought you did attach drive(s) to any of these ports, they aren't being seen.
A different message format appears if the chip is set to IDE mode (http://www.techsupportforum.com/showthread.php?s=&threadid=10138&forumid=87) in the BIOS, but the meaning is the same.
If you do not want to see this message, either attach a hard drive to one of the ports, or go into your BIOS Setup utility and set your Onboard Promise Controller to "Disabled".
-clintfan
The Promise PDC20378 chip used on many motherboards will emit the following message when it is in RAID mode, but after a 7-second scan, it finds that no hard drives are attached to any of its ports. The chip supports 2 SATA ports (often labelled "SATA_RAID1" and "SATA_RAID2", and also one IDE port (often labelled "PRI_RAID").
FastTrak 378 (tm) BIOS Version 1.00.1.34
(c)2002-2005 Promise Technology, Inc. All rights reserved.
Scanning IDE drives.......
No drive attached to FastTrak controller, The BIOS is not installed.
The message is an informational warning only. It may be ignored. Its purpose is to tell you that in case you thought you did attach drive(s) to any of these ports, they aren't being seen.
A different message format appears if the chip is set to IDE mode (http://www.techsupportforum.com/showthread.php?s=&threadid=10138&forumid=87) in the BIOS, but the meaning is the same.
If you do not want to see this message, either attach a hard drive to one of the ports, or go into your BIOS Setup utility and set your Onboard Promise Controller to "Disabled".
-clintfan
Hiyado
新手上路
- 注册
- 2003-05-06
- 消息
- 151
- 荣誉分数
- 0
- 声望点数
- 0
i think ur motherboard has promise raid controller there, p4p800-e-deluxe, p4c800-deluxe or p4c800e-deluxe....If u only use normal ide harddrive, so u need to close promise raid in bios..There r 2 raids controllers in ur motherboard, 1 is promise for 0.1and 0+1. 1 is ich5 for 0 and 1.
