http://www.gendan.co.uk/article_6.html#top_of_page
Audi A4 & A6 (All years)
Turn off the ignition
Press and hold the button on the left side of the display while turning the ignition on
Service OIL will be displayed
Pull out the button on the right side of the display until the service prompt is cleared
The display should now read ---
If the above procedure does not work, outlined below is an alternative procedure:
With the ignition off, push the right button
Turn the ignition on and then pull the left button
This should clear the warning message
Return to top of page
BMW 2001 to current
Ignition Off (Position 0)
Press and Hold the trip odometer button while turning key to position 1 (ACCESSORY)
Keep the button depressed (about 5 secs.) until you see "Oil Service" or "Inspection" with "Reset" or "Re" in the display*
Press the button again and hold for approx. 5 secs. until "Reset" or "Re" flashes
While the display is flashing, briefly press the button again to reset the Service Interval. After the display has shown the new interval you should see "END SIA" for about 2 seconds
Note: that if the "Reset" or "Re" does not flash, then you have not met the minimum consumption level and cannot reset
*Note: On vehicles with "High" cluster, you will also see the amount of fuel (in litres) remaining until next service
Return to top of page
Ford Galaxy
With the ignition off, press the reset button under the mileage counter
Hold in reset button whilst turning the ignition on
After about 4 or 5 seconds (up to 30 seconds in some cases) the display should reset itself
Release the button and turn the ignition off
It may be necessary to repeat this process
Return to top of page
Vauxhall 1999 onwards
Turn Ignition Off
Hold Trip Reset In
Turn Ignition On
Still Holding Trip Reset wait for three dashes
Turn off Ignition
Turn on Ignition to confirm
Return to top of page
Volkswagen (with digital Odomoter)
The code on the mileage display when you start the car will read "IN01", "IN02" or similar. To remove this, use the following procedure (this should work on any VW with a digital odometer):
With the key out of the ignition find and press the odometer reset button (hold down)
Turn the ignition on (warning lights come on) wait about 10-15 sec until most or the lights are off (still pressing odometer reset button)
Turn ignition off (button still pressed) and remove the key
Release reset button
Interval should now be reset. If this is not the case, repeat the above procedure
Return to top of page
Volvo 1999-2000 - S / V / C70 Models
Press and Hold odometer reset button
Turn ignition switch to "run" position
After SRL flashes, release odometer reset button
Turn ignition off
Turn ignition back on to confirm reset
Return to top of page
Volvo 1998 - S80 Models
Turn ignition switch to position 1
Press and hold the odometer reset button
Turn ignition switch to position 2
Wait until service light blinks and then release odometer button
Return to top of page
Volvo 1999-2000 - S80 Models
Turn ignition switch to position 1
Press and hold "day counter reset button"
Turn ignition switch to position 2
Continue holding day counter for approx. 10 seconds
After SRL flashes, release day counter button
Should hear "beep-beep" to confirm command accepted
Return to top of page
Volvo 2001 - XC 70 Models
The following steps must be completed with no longer than 5 seconds between each step:
Make sure the trip meter is in T-1
Turn ignition key to position 1
Press and hold trip meter button until zero is shown
While still holding the trip meter, turn key to position 2
When original trip mileage returns, release the trip reset button
Turn key to off
Audi A4 & A6 (All years)
Turn off the ignition
Press and hold the button on the left side of the display while turning the ignition on
Service OIL will be displayed
Pull out the button on the right side of the display until the service prompt is cleared
The display should now read ---
If the above procedure does not work, outlined below is an alternative procedure:
With the ignition off, push the right button
Turn the ignition on and then pull the left button
This should clear the warning message
Return to top of page
BMW 2001 to current
Ignition Off (Position 0)
Press and Hold the trip odometer button while turning key to position 1 (ACCESSORY)
Keep the button depressed (about 5 secs.) until you see "Oil Service" or "Inspection" with "Reset" or "Re" in the display*
Press the button again and hold for approx. 5 secs. until "Reset" or "Re" flashes
While the display is flashing, briefly press the button again to reset the Service Interval. After the display has shown the new interval you should see "END SIA" for about 2 seconds
Note: that if the "Reset" or "Re" does not flash, then you have not met the minimum consumption level and cannot reset
*Note: On vehicles with "High" cluster, you will also see the amount of fuel (in litres) remaining until next service
Return to top of page
Ford Galaxy
With the ignition off, press the reset button under the mileage counter
Hold in reset button whilst turning the ignition on
After about 4 or 5 seconds (up to 30 seconds in some cases) the display should reset itself
Release the button and turn the ignition off
It may be necessary to repeat this process
Return to top of page
Vauxhall 1999 onwards
Turn Ignition Off
Hold Trip Reset In
Turn Ignition On
Still Holding Trip Reset wait for three dashes
Turn off Ignition
Turn on Ignition to confirm
Return to top of page
Volkswagen (with digital Odomoter)
The code on the mileage display when you start the car will read "IN01", "IN02" or similar. To remove this, use the following procedure (this should work on any VW with a digital odometer):
With the key out of the ignition find and press the odometer reset button (hold down)
Turn the ignition on (warning lights come on) wait about 10-15 sec until most or the lights are off (still pressing odometer reset button)
Turn ignition off (button still pressed) and remove the key
Release reset button
Interval should now be reset. If this is not the case, repeat the above procedure
Return to top of page
Volvo 1999-2000 - S / V / C70 Models
Press and Hold odometer reset button
Turn ignition switch to "run" position
After SRL flashes, release odometer reset button
Turn ignition off
Turn ignition back on to confirm reset
Return to top of page
Volvo 1998 - S80 Models
Turn ignition switch to position 1
Press and hold the odometer reset button
Turn ignition switch to position 2
Wait until service light blinks and then release odometer button
Return to top of page
Volvo 1999-2000 - S80 Models
Turn ignition switch to position 1
Press and hold "day counter reset button"
Turn ignition switch to position 2
Continue holding day counter for approx. 10 seconds
After SRL flashes, release day counter button
Should hear "beep-beep" to confirm command accepted
Return to top of page
Volvo 2001 - XC 70 Models
The following steps must be completed with no longer than 5 seconds between each step:
Make sure the trip meter is in T-1
Turn ignition key to position 1
Press and hold trip meter button until zero is shown
While still holding the trip meter, turn key to position 2
When original trip mileage returns, release the trip reset button
Turn key to off
