WebExplorer
知名会员
- 注册
- 2005-11-08
- 消息
- 96
- 荣誉分数
- 5
- 声望点数
- 118
已经悄悄话各位。请查看。 谢谢！
costoco的shed有问题，可是装完才发现，怎么办？
- 主题发起人 米米小米
- 开始时间
searched from redflag
I have the exact same issue and I beleive it is becasue I stripped the two screws in each corner above the doors. I removed the screws and squeezed in a bunch of silicone and reset the screws...fingers crossed. I now have an issue with the two doors being about 1/2" apart and not joining/latching correctly, now to figure that problem out
I have the same issue. I didn't strip the two screws...was very careful with the screws and the torque. I am quite eager to know if squeezing in silicone solved the problem.( Or Should I have to apply silicone to seal the roof joints).
May 21st, 2013, 08:40 AM
I have the shed installed last weekend. Over this past week, we had some heavy rain and what I have found water dripping from the inside near the two corners of the entrance door. upon looking carefully it was caused by water seeping in from the connection seam of the gable roof of the entrance (which I assume is normal as the seams were not sealed), and it sort of collected at the trough of one of the metal support which support the roof... I guess it suppose to channel and drain the water to the outside from the two upper corners near the door, but instead, I guess it overflows and drip inside instead. Anyone else have similar issue? Other than that there is no water leak .I have the exact same issue and I beleive it is becasue I stripped the two screws in each corner above the doors. I removed the screws and squeezed in a bunch of silicone and reset the screws...fingers crossed. I now have an issue with the two doors being about 1/2" apart and not joining/latching correctly, now to figure that problem out
rbhattac
May 21st, 2013, 11:54 PM
I have the exact same issue and I beleive it is becasue I stripped the two screws in each corner above the doors. I removed the screws and squeezed in a bunch of silicone and reset the screws...fingers crossed. I now have an issue with the two doors being about 1/2" apart and not joining/latching correctly, now to figure that problem outI have the same issue. I didn't strip the two screws...was very careful with the screws and the torque. I am quite eager to know if squeezing in silicone solved the problem.( Or Should I have to apply silicone to seal the roof joints).
