From the front control panel message, Ready or Ready to Plot, press ENTER.
Press the Up arrow key until I/O Setup appears, and then press ENTER.
Press the Up arrow key until Modular appears, and then press ENTER.
From the front control panel message, Cfg Network=No, press ENTER.
Press the Up arrow key to change to Yes, and then press ENTER.
Using the Arrow keys, scroll to Cfg TCP/IP=No appears, and then press ENTER.
Scroll to Yes, and press ENTER.
Press the Up arrow key until BootP=Yes appears, and press ENTER.
Press the Up arrow key to change to No. Press ENTER (When using BootP or DHCP, keep the setting BOOTP = YES *. The BootP or DHCP server will configure the TCP/IP parameters on the HP Jetdirect. No other TCP/IP configuring is necessary.
