Try to reset the whole alarm module.
1. connect the battery.
2. follow the blow steps,
Resetting the Module (without the Plug-in valet button):
Resetting the Module is not a required process. Most of the time, you can avoid resetting
the Module by fixing the issue directly at the root of the cause.
To r t ton: ese the Module, without using the plug-in Valet but
1. Flash the hood pin switch.
2. In 10 seconds or less, press the Brake Pedal 6 times.
3. The Parking Lights will flash 8 times confirming the Reset.
On some vehicles, such as, BMW, and certain Volkswagens, etc., pressing the Brake
pedal without the key in the Ignition ON position, will not work and therefore you will need
fused test lead, at the to hot wire the brake Pedal?manually jumping 12Volts, with a
Brake Pedal switch.
Resetting the Module (with the Plug-in valet button):
To reset the module:
1. Make sure that the valet and ignition are both OFF and that the hood is up.
• Hold the hood pin-switch down for 4 seconds.
• Release the pin-switch.
The parking lights should come on.
• With parking lights on, immediately push and release the pin-switch again.
The parking lights will stay on for up to 20 seconds.
Press the valet button 6 times or more until the parking lights start to flash.
2. The parking lights will flash 8 times.
Note
After a reset has been performed, the system will set all options back to
their default values and erase all transmitter codes. (See Programming
Options p.11 for default values.)
