请问一个关于电方面的问题.
- 主题发起人 悠着点
- 开始时间
- 注册
- 2003-03-12
- 消息
- 1,708
- 荣誉分数
- 21
- 声望点数
- 148
检查下主卧室里有没有大功率用电的电器 如果有拔掉它.
或者两个电器互相冲突 容易跳闸
或者两个电器互相冲突 容易跳闸
luvmonbora
新手上路
- 注册
- 2008-05-01
- 消息
- 173
- 荣誉分数
- 1
- 声望点数
- 28
A faulty breaker got me once, the following procedures fixed the issue.
Replacing a Breaker in Your Panel
Replacing a Breaker in Your Panel
luvmonbora
新手上路
- 注册
- 2008-05-01
- 消息
- 173
- 荣誉分数
- 1
- 声望点数
- 28
It took me couple of minutes, you can get the breaker from Home Depot, around $3 tax in I think. It's a black piece similar to the ones in figure 4 and 6. I was lucky.
An electrician can do some inspection.
An electrician can do some inspection.
first, call Hydro One. tell them your problem.
their cable may be cut down by mouse(地线,NOT 火线). i met the kind of the problem before. only some of outlets didn't work. i tried to fix that like you. checked the panel and big electric equipements, that cost me one day. the workers from Hydro just use five min. to recover the power, even didn't come in my house.
their cable may be cut down by mouse(地线,NOT 火线). i met the kind of the problem before. only some of outlets didn't work. i tried to fix that like you. checked the panel and big electric equipements, that cost me one day. the workers from Hydro just use five min. to recover the power, even didn't come in my house.
- 注册
- 2002-03-11
- 消息
- 19,994
- 荣誉分数
- 5,254
- 声望点数
- 373
haaa... i was stuck with the same problem for one week last year. it is about the correct method to turn on those GFCI breakers (normally with TEST button):
If this kind of breakers cut off the power, their handle/switch always stays in middle of the state (neither "ON" nor "OFF"). In order to turn on, you will need to pull the handle to "OFF" at first then push it back to "ON". You can not just finish the job by simply pushing it back to "ON".
Those breakers are very expensive, so don't throw away the old ones before you have tried everything you could
If this kind of breakers cut off the power, their handle/switch always stays in middle of the state (neither "ON" nor "OFF"). In order to turn on, you will need to pull the handle to "OFF" at first then push it back to "ON". You can not just finish the job by simply pushing it back to "ON".
Those breakers are very expensive, so don't throw away the old ones before you have tried everything you could
谢谢啦. 搞定了.
按照楼上和"基础墙"介绍的方法试了下, 拔掉所有的主卧室里所有插座上的电器, 然后在楼下总开关的那个控制键拨到OFF的位置, 再按TEST键, 恢复后在拨回ON的位置就可以了.
