EHS fence 安装日记

我想问一下,挖完坑以后,把水泥灰倒入坑内的立柱周围,加水,而不是事先搅拌好,然后也没有等水泥完全干,马上安装栅栏板,小半天就弄完,这样的程序对吗?(现在的立柱周围的地面出现很多小的坑):confused:
先加水泥再加水不对呀。如果用的是Fast set concrete mix, like Instant Post, 应该是先加水,再倒水泥的。
 
先加水泥再加水不对呀。如果用的是Fast set concrete mix, like Instant Post, 应该是先加水,再倒水泥的。

我记得是先加水泥再加水的。

How do you set a post with QUIKRETE® Fast-Setting Concrete Mix?
Dig a hole that is about 3 times the diameter of the post with a depth of 1/3 the overall post length. Position the post and check that it is straight. Pour the QUIKRETE® Fast-Setting Concrete Mix dry from the bag into the hole until it reaches 3 to 4" from the top. Pour water onto the dry mix and allow it to soak in. Add water until the powder is thoroughly wet. This will take about one gallon of water for each 50 pound bag depending on soil conditions. If the hole is deeper than 2 1/2', do the operation in lifts of no more than 2 1/2' each. Fill the remainder of the hole with soil or the sod dug from the hole.
 
我记得是先加水泥再加水的。

看来先后都可以:
Q: How can I set my post without mixing the concrete with water first?
A: Sakrete Fast Setting Concrete Mix can be used for this application by digging the hole to desired size. Place approximately 2 inches of gravel at the bottom of the hole then fill the hole 1/3 with water, place the pole and pour or shovel the Fast Setting Concrete Mix into the hole adding more water and dry mix until hole is full.
不过我认为先加水很难保证水能渗透到每个地方。粉尘的表面张力是很大的,搅拌过水泥的人都知道。
所以在上面的操作指南里,它强调每次不能超过2 1/2“高。这点很重要。操作起来很难保证。
 
看看这活儿干的。整个driveway上都是他们踩的脚印。
要求没有脚印比较苛刻,自己做也避免不了。只要没有泥土就可以了吧。
 
你没看明白,这是脚上踩上水泥粉印上的脚印,冲不掉的。
比泥土狠多了。:crying:

你的问题我们之前和EHS反应过了,他们说这可以清除掉,最近我们在督促他们完成修补工作,你的这个问题也在list里面,在适当的时候他们会过来完成的。
 
你的问题我们之前和EHS反应过了,他们说这可以清除掉,最近我们在督促他们完成修补工作,你的这个问题也在list里面,在适当的时候他们会过来完成的。

谢团长。比较闹心的是,我们秋天刚刷过driveway,没想到还没过冬就给踩花了。所以异常气愤。:blowzy:
 
谢团长。比较闹心的是,我们秋天刚刷过driveway,没想到还没过冬就给踩花了。所以异常气愤。:blowzy:

能理解,过一点时间我们会再联系他们并检查所有的修复进度。
 

相关推荐

后退
顶部